Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Transmission line
   + Coupling
   + Driveshafts
   - Power shafts
      Removal and installation of a rotary fist, replacement of a spherical support
      Removal and installation of a flange of a forward power shaft and two-row radial-stop ball bearing of a forward nave
      Removal and installation of back stupichny assembly, replacement of a spherical support
      Removal and installation of a flange of a back power shaft and two-row radial-stop ball bearing of a back nave
      Removal and installation of power shafts
      Replacement of boots of hinged assemblies of power shafts
   + Transfer case and differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of a flange of a forward power shaft and two-row radial-stop ball bearing of a forward nave

Details of installation of a flange of a forward power shaft and two-row radial-stop stupichny bearing


 PERFORMANCE ORDER

  1. Details of installation of a flange of a forward power shaft and the radial-stop stupichny bearing are shown on an illustration to which all references which are found in the text belong.
  2. Remove a rotary fist (see the Section Removal and installation of a rotary fist, replacement of a spherical support).
  3. By means of an extractor dismantle from a rotary fist a flange of a power shaft (9).
  4. By means of special nippers remove a lock ring (9r).
  5. By means of an extractor release from a rotary fist the two-row radial-stop bearing (9n).
  6. In case of need release an internal holder of the bearing from a flange of a power shaft and replace the last.
  7. Installation is made upside-down, in conclusion make necessary adjustments of angles of installation of wheels.