Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
- Brake and auxiliary systems
   General information and security measures
   Check of the brake system on leaks
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Check of retaining valve
   Removal and installation of the main brake cylinder
   Removal and installation of the vacuum amplifier of brakes and sensor of the course of a diaphragm of BAS
   Removal and installation of the ETS/ESP hydromodulator
   Removal and installation of the hydraulic lines laid between GTTs and the ETS/ESP hydromodulator
   Assessment of degree of wear and replacement of brake shoes
   Replacement of brake hoses
   Removal and installation of a support
   Removal and installation of a brake disk
   Replacement of boots of the parking brake
   Pumping of the brake system
   Removal and installation of pedal knot and sensor switch of stoplights
   Removal and installation of a pedal of raising of the parking brake
   Removal and installation of hummock assembly of the drive of the parking brake
   Adjustment of the drive of the parking brake
   Removal and installation of wheel ABS/ETS/ESP sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of a pedal of raising of the parking brake

Details of installation of a pedal of raising of the parking brake


 PERFORMANCE ORDER

In total самоконтрящиеся bolts and nuts are subject to replacement without fail!

  1. Details of installation of a pedal of raising of the parking brake are shown on an illustration to which all references which are found in the text belong.
  2. Make a preliminary tightness of the regulator of a weak point (the compensation lever) of a driving cable.
  3. Uncover (71) pedal assembly.
  4. Remove the sensor switch of raising of the parking brake (S12).
  5. Disconnect a cable (85) from a tension earring on a pedal (75) and release it from a clamp by means of special adaptation (043), - try not to drop a rubber ring (85s).
  6. Weaken a bolt (72) and remove pedal assembly (75).

Do not release bolts with TORX heads from the back party of assembly!

  1. Remove an arm (77a) and disconnect a cable of an otpuskaniye of the parking brake (79) from the operating lever (77), further disconnect a cable from pedal assembly (75) by means of adaptation (010) and remove it.
  2. Installation is made upside-down. In conclusion unload the weak point regulator (the compensation lever) and make adjustment of the drive of the parking brake (see the Section Adjustment of the Drive of the Parking Brake).