Mercedes M-Class W163

since 1997 release

Repair and operation of the car


Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Filling and "pumping" of the steering pump
      Check of a pressure of the steering pump
      Replacement of a collar of fastening of a hose of a path of cooling of GUR liquid
      Assessment of a condition of hinges of steering drafts and boots of a case of rack transfer
      Removal and installation of the steering pump
      Replacement of boots of a case of the steering mechanism
      Removal and installation of tips of steering draft
      Removal installation of entrance knot of the steering mechanism
      Removal and installation of the steering mechanism
      Dismantling of the mechanical regulator of a steering column
      Removal and installation of a steering wheel and spiral contact drum of a steering column
      Removal and installation of the cylinder of the lock of ignition
      Removal and installation of the lock of blocking of a steering column
      Removal and installation and shirts of a steering column
   + Suspension bracket geometry
+ Body
+ Onboard electric equipment

Removal and installation of tips of steering draft

In total самоконтрящиеся bolts and nuts are subject to replacement without fail!

External tip

Details of installation of an external tip of steering draft


 PERFORMANCE ORDER

  1. Details of installation of an external tip of steering draft are shown on an illustration to which all references which are found in the text belong.
  2. By means of a suitable stripper release the hinge of a tip of steering draft (10a) from a rotary fist.
  3. Having recorded a tip not movably (shooter), release a lock-nut (10i), the nut is subject to replacement without fail.
  4. Previously having marked its adjusting situation, remove a tip (10).
  5. Installation is made upside-down, - track correctness of combination of the tags put in the course of dismantle.

Internal tip

Removal/installation of an internal tip of steering draft

Left draft

Left draft

Right draft


 PERFORMANCE ORDER

  1. The corresponding illustrative material is presented on illustrations to which all references which are found in the text belong.
  2. Remove an external tip (see above).

At service of the right draft remove also left boot.

  1. Holding a lath not movably Rozhkov the key on 24 mm which is put on special lysk by means of Rozhkova of a nozzle on 36 or 38 mm (012) turn out the hinge of an internal tip (12a/12b), - it is not necessary to use extenders to the handle of a key or to use a sledge hammer.
  2. Installation is made upside-down.