Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
- Power supply system and production of the fulfilled gases
   + Power supply system of petrol engines
   - Power supply system of diesel engines
      General information
      Checks of system of injection of fuel
      Service of components of an inlet air path
      Service of components of the drive of a butterfly valve
      Depletion of the fuel tank
      Removal and installation of the sensor of a reserve of fuel
      Removal of air from a contour of low pressure of a fuel path, - on the example of the series 612 engine
      Removal and installation of the preliminary fuel pump
      Removal and installation of the fuel pump of high pressure (FPHP)
      Removal and installation of the fuel distributive highway and nozzles
      Removal and installation of the sensor of pressure in the fuel highway
      Removal and installation of the electric locking valve, - model 163.113
      Removal and installation of the valve regulator of pressure of fuel
      Removal and installation of valvate assembly on models 163.128
      Removal and installation of a cooler of fuel on models 163.113
      Removal and installation of the module of management of fuel injection
      Removal and installation of the fuel tank
   + Systems of release and decrease in toxicity of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Service of components of the drive of a butterfly valve

Greasing, check of mobility and condition of hinged connections of the lever drive of a butterfly valve

See the Section Service of Elements of the Drive of a Butterfly Valve adjusted for features of a concrete design.

Check and adjustment of the drive of a butterfly valve

Adjustment of the drive of a butterfly valve on diesel models (engines of series 612 and 628)


 PERFORMANCE ORDER

  1. Illustrative material on check and adjustment of the drive of a butterfly valve on models 163.136 (the series 111 engine) is presented on an illustration to which all references which are found in the text belong.
  2. Check a state and freedom of the course of the returnable lever (31/1) and a driving cable (32). Replace defective components.
  3. Squeeze out the accelerator pedal so that the returnable lever (31/1) rested against the limiter (b).
  4. Rotating to the left at the squeezed-out pedal, release the limiter of the maximum opening of the gate (38).
  5. Rotating to the right give the limiter (38) into position.
  6. Release the accelerator pedal and make sure that the returnable lever rests against the limiter of idling (and).
  7. Make sure of completeness of the course of a butterfly valve.