Repair and service Mercedes Benz M - The Class W163 - Replacement of lamps of saloon lamps//since 1997 release /

Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   General information and precautionary measures
   Search of causes of failures of electric equipment
   Safety locks - the general information
   Chain breakers - the general information
   The relay - the general information and check of serviceability of functioning
   Digital tire of data of CAN
   + Assembly blocks, elements of control systems
   + Dashboard, switches, traveling computer
   + Driving electric motors
   - Alarm and lighting fixtures, sensors of a rain and temperature of external air
      Removal and installation of horns of a horn
      Removal and installation of block headlights, replacement of lamps
      Removal, installation and replacement of lamps of fog lights
      Removal and installation of back lamps, replacement of lamps
      Removal and installation of the central stoplight of the top level
      Removal and installation of lamps of illumination of registration plate
      Replacement of lamps of saloon lamps
      Removal and installation of the sensor of temperature of external air
      Removal and installation of the sensor of a rain (at the corresponding complete set)
   + Systems of additional safety (SRS)
   + Audio system
   + Schemes of electric connections



Replacement of lamps of saloon lamps

Forward lamps

Design of the forward saloon lamp


 PERFORMANCE ORDER

  1. The design of the forward saloon lamp is shown on an illustration to which all references which are found in the text belong.
  2. Remove the ceiling console (1).
  3. Take the lamp needing replacement (2).
  4. Having released from clamps, remove from the console panel (1) cartridges of a lamp (3).
  5. Take the switch (4) from a reflector (6).
  6. Turn out screws (5) and, having hooked, carefully release a reflector (6) of the lamp from the console panel (1).
  7. Installation is made upside-down. In conclusion check serviceability of functioning of lamps.

Back lamp

Design of the back saloon lamp


 PERFORMANCE ORDER

  1. The design of the back saloon lamp is shown on an illustration to which all references which are found in the text belong.
  2. Having hooked, cast away a plafonny cover (1), having lowered it against the stop in the limiter.
  3. At the corresponding complete set disunite the contact socket of an electrical wiring of the indicator display of the Parktronic system.
  4. Release assembly of the saloon lamp (E15/3) from a ceiling upholstery, - pull the rear edge of assembly down and at the same time give it forward.
  5. Disunite the contact socket (2) electrical wirings of the lamp.
  6. In case of need remove the failed lamp.
  7. Installation is made upside-down. Make sure of serviceability of functioning of the lamp.