Repair and service Mercedes Benz M - The Class W163 - Removal and installation of the sensor of Hall of the camshaft, - petrol engines of series 112, 113 and diesel engines of a series 612//with of 1997 of release /

Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply system and production of the fulfilled gases
- Systems of electric equipment of the engine
   - Systems of ignition and engine management
      Main data and security measures
      Checks of a control system of ignition and injection
      Search of malfunctions - the general information and preliminary checks
      Check and adjustment of a corner of an advancing of ignition
      Spark plugs
      Removal and installation of coils of ignition, - petrol models
      Removal and installation of the sensor of provision of a bent shaft (CKP)
      Removal and installation of the sensor of position of the camshaft (CMP), - the series 111 engine
      Removal and installation of the sensor of Hall of the camshaft, - petrol engines of series 112, 113 and diesel engines of a series 612
      Removal and installation of sensors of a detonation (KS), - petrol engines
   + System of preheat of the diesel engine
   + Diagnostics of systems of electronic control and diagnostic equipment
   + Systems of a charge and start
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Removal and installation of the sensor of Hall of the camshaft, - petrol engines of series 112, 113 and diesel engines of a series 612

Petrol engines

Details of installation of the sensor of Hall of the camshaft on petrol engines of series 112 and 113 are shown on an illustration, - do not forget to replace a sealing ring.

Location of the sensor of Hall (B6/1) of the camshaft of petrol engines of series 112 and 113

Diesel engines

Details of installation of the sensor of Hall of the camshaft of diesel engines of a series and 612


 PERFORMANCE ORDER

  1. Details of installation of the sensor of Hall of the camshaft of the diesel engine of a series 612 are shown on an illustration to which all references which are found in the text belong.
  2. Open a cowl and record it in vertical position.
  3. Turn out 4 screws, release 3 clamps and remove the right panel of finishing of the power unit.
  4. Disunite the contact socket of an electrical wiring (1).
  5. Turn out a fixing bolt (2) and remove the sensor of Hall (B6/1).
  6. Installation is made upside-down, - do not forget to replace a sealing ring.