Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Transmission line
   + Coupling
   + Driveshafts
   - Power shafts
      Removal and installation of a rotary fist, replacement of a spherical support
      Removal and installation of a flange of a forward power shaft and two-row radial-stop ball bearing of a forward nave
      Removal and installation of back stupichny assembly, replacement of a spherical support
      Removal and installation of a flange of a back power shaft and two-row radial-stop ball bearing of a back nave
      Removal and installation of power shafts
      Replacement of boots of hinged assemblies of power shafts
   + Transfer case and differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


Removal and installation of a rotary fist, replacement of a spherical support

Removal/installation of a fist

Details of installation of a rotary fist


 PERFORMANCE ORDER

  1. Details of installation of a rotary fist are shown on an illustration to which all references which are found in the text belong.
  2. Remove the corresponding forward wheel.
  3. Give a stupichny nut (65a), - the nut is subject to replacement without fail.
  4. Disconnect an electrical wiring from the wheel sensor and the indicator of wear of brake shoes.
  5. Remove a brake disk (see the Head Tormoznaya and auxiliary systems).
  6. Remove from assembly of a rotary fist the wheel sensor assembled with the basic arm.
  7. Disconnect steering draft (10) from a rotary fist, estimate a condition of a boot and degree of wear of a tip, in case of need make replacement.
  8. By means of a stripper release a spherical support from the top managing director of the lever (6) (see the Head Podvesk and steering). Check a condition of a boot, estimate degree of wear of spherical assembly, in case of need make replacement.
  9. By means of an extractor to a vypressuyta from the flange a forward power shaft.
  10. Having recorded a rotary fist, a vypressuyta a spherical support from the lower rotary fist. Check a condition of a boot, estimate degree of wear of spherical assembly, in case of need make replacement.
  11. Take assembly of a rotary fist (5) from under the car.
  12. Installation is made upside-down, - in case of need use the corresponding special tool. Track correctness of laying and connection of an electrical wiring.

Replacement of a spherical support

Details of installation of the lower spherical support in a rotary fist


 PERFORMANCE ORDER

  1. Remove a rotary fist (see above).
  2. Disconnect and develop a brake board.
  3. Vypressuyte a spherical support (7) from a rotary fist (5).
  4. By means of a koronchaty nut and a suitable key press a new spherical support against the stop in a rotary fist, - replace a nut.
  5. Put into place a brake board and install a rotary fist on the car (see above).