Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
- Transmission line
   - Coupling
      Assessment of degree of wear of the conducted clutch plate
      Removal, installation and check of coupling
      Removal and installation of the main cylinder
      Removal and installation of the executive cylinder of coupling
      Removal of air from a hydraulic path of the drive of coupling
   + Driveshafts
   + Power shafts
   + Transfer case and differentials
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal, installation and check of coupling

Details of installation of components of assembly of coupling


 PERFORMANCE ORDER

  1. Illustrative material according to procedures of removal/installation of components of coupling is given in an illustration to which all references which are found in the text belong.
  2. Remove RKPP (see the Head the Manual box of gear shifting).
  3. In stages, no more than on 1 ÷ 1.5 turns for approach, turn out fixing bolts (9) (Allen) and remove assembly of a basket of coupling (6) and the conducted disk (5), - when using of the aligning mandrel (012) act strictly according to instructions of manufacturers of adaptation.
  4. Estimate a condition of the conducted and press disks.
  5. Estimate a flywheel condition.
  6. Replace defective components.
  7. On the models equipped with RKPP of a series 717.4 remove the release bearing (7) and the bifurcate lever of switching off of coupling (8). Estimate degree of wear of components, in case of need make replacement.
  8. On the models equipped with RKPP of a series 716.6 check the central operator for existence of signs of wear and development of leaks. In case of need make replacement.
  9. Installation is made upside-down, - track correctness of installation of the conducted disk, on models with RKPP of a series 717.4 grease deepenings in the bifurcate lever of switching off of coupling under a spherical bolt of a case of a box and a rod of a pusher of the executive cylinder (arrow).