Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ Power supply system and production of the fulfilled gases
- Systems of electric equipment of the engine
   + Systems of ignition and engine management
   + System of preheat of the diesel engine
   + Diagnostics of systems of electronic control and diagnostic equipment
   - Systems of a charge and start
      General information
      The rechargeable battery - the general information, recommendations about service
      System of a charge - general information and security measures
      Check of system of a charge
      Removal and installation of the generator
      Removal and installation of a driving pulley of the generator
      Removal and installation of the regulator of tension
      System of start of the engine - the general information and precautionary measures
      Removal and installation of a starter
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of a driving pulley of the generator

When replacing the generator with a run more than 100 000 km should be replaced also and its driving pulley.

Petrol models

Details of installation of a driving pulley of the generator on petrol models

1 — Flantsovannaya a nut
2 — a generator Shaft

3 — Mnogoruchyeva a pulley

Details of installation of a driving pulley of the generator on petrol models

4 — the Bilateral six-sided face head


 PERFORMANCE ORDER

  1. To detail of installation of a driving pulley of the generator on petrol models it is shown on illustrations to which all references which are found in the text belong.
  2. Remove the generator (see the Section Removal and installation of the generator).
  3. Block a shaft of the generator (2) from a provorachivaniye by threading of the screw-driver in a bilateral six-sided head (4), release a flantsovanny nut (1).
  4. Remove mnogoruchyevy a driving pulley (3).
  5. Installation is made upside-down.

Diesel models

Details of installation of a driving pulley of the generator on diesel models

1 — Mnogoruchyeva a pulley
2 — a generator Shaft

3 — the Face head
4 — the Protective cap


 PERFORMANCE ORDER

  1. To detail of installation of a driving pulley of the generator on petrol models it is shown on an illustration to which all references which are found in the text belong.
  2. Remove the generator (see the Section Removal and installation of the generator).
  3. Remove a protective cap (4).
  4. By means of a face head (3) release a fixing nut and remove a driving pulley of the generator (1), - blocking of a shaft (2) is made by means of the equipped notch of section of a face head (3).
  5. Installation is made upside-down.