Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
- Automatic transmission
   Search of malfunctions - the general information
   The general principles of functioning of system transmission, the operating signals
   Adjustment of the drive of switching of AT
   Removal and installation of the electrohydraulic control unit of switchings
   Removal and the AT installation with the hydrotransformer
   Removal and installation of the selector module
   Removal and installation of a cable of blocking of the electronic switch of ignition (EIS)
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Adjustment of the drive of switching of AT

Design of the drive of switching of AT

33 — the Executive lever
63 — Draft of switching
97 — the Intermediate lever

98 — a draft Head
99 — the Bolt
107 — the Basis of selector assembly


 PERFORMANCE ORDER

  1. The design of the drive of switching of AT is shown on an illustration to which all references which are found in the text belong.
  2. Tire out the car on the elevator, lift and level strictly horizontally.
  3. Transfer the executive lever (33) to situation "D" and ask the assistant to hold it in this situation during the whole time of implementation of the procedure.
  4. Connect a head of thirst (98) for the intermediate lever (97) and fix it by clamps.
  5. Fill draft (63) in a head, connect it to the lever (33) and fix by clamps.
  6. Having pressed a head (98), tighten a bolt (99), - track that draft (63) and a head (98) were not turned, and the lever (33) remained in situation "D" all the time.
  7. Check serviceability of functioning of the drive.