Repair and service Mercedes Benz M - The Class W163 - Removal and installation of a flywheel / a driving disk//since 1997 release /

Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
- Engine
   Check of compression pressure in cylinders
   Check of the engine by means of the vacuum gage
   Replacement of a belt of the drive of auxiliary units and elements of the mechanism of its tension
   - Petrol models
      Removal and installation of the engine
      Removal and installation of covers of the GRM drive
      Replacement of a gas-distributing chain
      Removal and installation of components of the GRM drive
      Installation of basic position of camshafts
      Verification of the basic provision of a balancing shaft (only series 112 engines)
      Removal and installation of the GRM components
      Removal and installation of a head(s) of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Removal and installation of a face cover, replacement of a back epiploon of a bent shaft
      Removal and installation of a damper of tortional fluctuations / pulley of a driving belt
      Removal and installation of a flywheel / driving disk
      Removal and installation of support of a suspension bracket of the power unit
      Service of the lubrication system
   + Diesel models
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Removal and installation of a flywheel / driving disk

M111

Details of installation of a flywheel / a driving disk on the series 111 engine


 PERFORMANCE ORDER

  1. Details of installation of a flywheel / a driving disk on the engine of a series 111 are shown on an illustration to which all references which are found in the text belong.
  2. Remove transmission (see the Head the Manual box of gear shifting and Avtomatichekhky transmission).
  3. On models remove coupling from RKPP (see the Head the Transmission line).
  4. Install the lock (3).
  5. Turn out fixing bolts (1).
  6. Remove a flywheel (86) (single-section, or two-section) / a driving disk (98).
  7. On models remove a back washer from AT (3).
  8. Installation is made upside-down.

Fixing bolts are subject to replacement without fail.

M112/113

Details of installation of a driving disk on engines of series 112 and 113


 PERFORMANCE ORDER

  1. Details of installation of a driving disk on engines of series 112 and 113 are shown on an illustration to which all references which are found in the text belong.
  2. Remove transmission (see the Head Avtomatichekhky transmission).
  3. Install the lock (6).
  4. Turn out bolts of fastening of a driving disk (1) to an end face of a pin of a bent shaft (5).
  5. Remove a washer (2).
  6. Remove a driving disk (1).
  7. Installation is made upside-down, - unambiguity of landing of a disk is guaranteed by existence of a cylindrical pin (4).

Fixing bolts are subject to replacement without fail.