Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
- Brake and auxiliary systems
   General information and security measures
   Check of the brake system on leaks
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Check of retaining valve
   Removal and installation of the main brake cylinder
   Removal and installation of the vacuum amplifier of brakes and sensor of the course of a diaphragm of BAS
   Removal and installation of the ETS/ESP hydromodulator
   Removal and installation of the hydraulic lines laid between GTTs and the ETS/ESP hydromodulator
   Assessment of degree of wear and replacement of brake shoes
   Replacement of brake hoses
   Removal and installation of a support
   Removal and installation of a brake disk
   Replacement of boots of the parking brake
   Pumping of the brake system
   Removal and installation of pedal knot and sensor switch of stoplights
   Removal and installation of a pedal of raising of the parking brake
   Removal and installation of hummock assembly of the drive of the parking brake
   Adjustment of the drive of the parking brake
   Removal and installation of wheel ABS/ETS/ESP sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Replacement of brake hoses

Details of installation of a flexible hose of the brake mechanism of a forward wheel (on the example of the models equipped with supports of floating type)

Details of installation of a flexible hose of the brake mechanism of a back wheel (on the example of the models equipped with supports of floating type)


 PERFORMANCE ORDER

  1. Details of installation of brake hoses are shown on illustrations to which all references which are found in the text belong.
  2. Disconnect from a hose (5) the brake line (51), - at once to a zakuporta the open end of the brake line.
  3. During the work on brake mechanisms of forward wheels release from a clamp on a hose (51) an electrical wiring from sensors of wear of blocks and frequency of rotation of wheels, then turn out a hollow bolt of the nipple socket and disconnect a hose from a support.
  4. During the work on brake mechanisms of forward wheels disconnect a hose, having turned out the union from a support.
  5. Installation is made upside-down, - do not forget to replace sealing washers of nipple sockets.
  6. In conclusion modify the level of hydraulic liquid and pump over the brake system (see the Section Pumping of the Brake System).