Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
- Brake and auxiliary systems
   General information and security measures
   Check of the brake system on leaks
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Check of retaining valve
   Removal and installation of the main brake cylinder
   Removal and installation of the vacuum amplifier of brakes and sensor of the course of a diaphragm of BAS
   Removal and installation of the ETS/ESP hydromodulator
   Removal and installation of the hydraulic lines laid between GTTs and the ETS/ESP hydromodulator
   Assessment of degree of wear and replacement of brake shoes
   Replacement of brake hoses
   Removal and installation of a support
   Removal and installation of a brake disk
   Replacement of boots of the parking brake
   Pumping of the brake system
   Removal and installation of pedal knot and sensor switch of stoplights
   Removal and installation of a pedal of raising of the parking brake
   Removal and installation of hummock assembly of the drive of the parking brake
   Adjustment of the drive of the parking brake
   Removal and installation of wheel ABS/ETS/ESP sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of the ETS/ESP hydromodulator

Details of installation of the ETS/ESP hydromodulator

DK — the First working diagonal contour
HL — To to a support of the brake mechanism of the left back wheel
HR — To to a support of the brake mechanism of the right back wheel

SK — the Second working diagonal contour
VL — To to a support of the brake mechanism of the left forward wheel
VR — To to a support of the brake mechanism of the right forward wheel


 PERFORMANCE ORDER

  1. Details of installation of the hydromodulator are shown on an illustration to which all references which are found in the text belong.
  2. Switch off ignition.
  3. Remove the tank of liquid of washing of glasses (see the Head Kuzov).
  4. Previously having marked, disconnect from the ETS/ESP hydromodulator hydraulic lines, - at once to a zakuporta the open ends of lines and nipple sockets.
  5. Remove the left forward wheel and a loker of protection of a wheel arch.
  6. Having released the bayonetny lock, disunite the 15-contact electric socket of the hydromodulator.
  7. Отболтив from the bearing plate, remove the hydromodulator and take it from a motive compartment through a wheel arch, previously having released the line of ventilation of the transfer case from clamps. In case of need lift up and remove an assembly plate from rubber pillows.
  8. Installation is made upside-down, - track correctness of connection of hydraulic lines.
  9. In conclusion pump over the brake system (see the Section Pumping of the Brake System) and clear memory of the module of system of onboard self-diagnostics (see the Head Sistemy of electric equipment of the engine).