Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
- Brake and auxiliary systems
   General information and security measures
   Check of the brake system on leaks
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Check of retaining valve
   Removal and installation of the main brake cylinder
   Removal and installation of the vacuum amplifier of brakes and sensor of the course of a diaphragm of BAS
   Removal and installation of the ETS/ESP hydromodulator
   Removal and installation of the hydraulic lines laid between GTTs and the ETS/ESP hydromodulator
   Assessment of degree of wear and replacement of brake shoes
   Replacement of brake hoses
   Removal and installation of a support
   Removal and installation of a brake disk
   Replacement of boots of the parking brake
   Pumping of the brake system
   Removal and installation of pedal knot and sensor switch of stoplights
   Removal and installation of a pedal of raising of the parking brake
   Removal and installation of hummock assembly of the drive of the parking brake
   Adjustment of the drive of the parking brake
   Removal and installation of wheel ABS/ETS/ESP sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Removal and installation of hummock assembly of the drive of the parking brake

In total самоконтрящиеся bolts and nuts are subject to replacement without fail!

Forward cable

Details of installation of a pedal of raising of the parking brake


 PERFORMANCE ORDER

  1. Details of installation of forward section of hummock assembly of the drive of the parking brake are shown on an illustration to which all references which are found in the text belong.
  2. Make a preliminary tightness of the regulator of a weak point (the compensation lever) of a driving cable.
  3. Disconnect a cable (85) from the intermediate lever (91) and by means of adaptation (043) release it from a clamp on the floor panel.
  4. Uncover, established at the left under the dashboard.
  5. Remove the carpet panel.
  6. By means of adaptation (043) disconnect a cable (85) from a pedal of the parking brake (75), - try not to drop a rubber ring (85s).
  7. Having given a nut, weaken a cable cover in a foot well.
  8. Remove a clamp (85a) and push a cable through the plug through passage (85b) in the transmission tunnel.
  9. Installation is made upside-down. In conclusion unload the weak point regulator (the compensation lever) and make adjustment of the drive of the parking brake (see the Section Adjustment of the Drive of the Parking Brake).

Back cable

Details of installation of back section of hummock assembly of the drive of the parking brake


 PERFORMANCE ORDER

  1. Details of installation of back section of hummock assembly of the drive of the parking brake are shown on an illustration to which all references which are found in the text belong.
  2. Take off boots of the parking brake (see the Section Replacement of Boots of the Parking Brake).
  3. Disconnect a cable (86) from the compensation lever (92).
  4. By means of adaptation (043) release a cable (86) from clamps on floor panels.
  5. Release a cable (86) from stupichny assembly.
  6. Installation is made upside-down.