Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
- Brake and auxiliary systems
   General information and security measures
   Check of the brake system on leaks
   Check of serviceability of functioning of the vacuum amplifier of brakes
   Check of retaining valve
   Removal and installation of the main brake cylinder
   Removal and installation of the vacuum amplifier of brakes and sensor of the course of a diaphragm of BAS
   Removal and installation of the ETS/ESP hydromodulator
   Removal and installation of the hydraulic lines laid between GTTs and the ETS/ESP hydromodulator
   Assessment of degree of wear and replacement of brake shoes
   Replacement of brake hoses
   Removal and installation of a support
   Removal and installation of a brake disk
   Replacement of boots of the parking brake
   Pumping of the brake system
   Removal and installation of pedal knot and sensor switch of stoplights
   Removal and installation of a pedal of raising of the parking brake
   Removal and installation of hummock assembly of the drive of the parking brake
   Adjustment of the drive of the parking brake
   Removal and installation of wheel ABS/ETS/ESP sensors
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



Replacement of boots of the parking brake

Details of installation of boots of the parking brake


 PERFORMANCE ORDER

  1. Details of installation of boots of the parking brake are shown on an illustration to which all references which are found in the text belong.
  2. Remove brake disks of back wheels (see the Section Removal and installation of a brake disk).
  3. By means of special adaptation (041) disconnect coupling springs (111).
  4. Remove anchor springs (107) and fingers (106).
  5. Take off brake boots (103) from a flange of a back power shaft (68).

If boots (103) burned, it is necessary to make their replacement in a set with coupling springs (111 and 112) and anchor elements (106 and 107).

  1. Disconnect a coupling spring (112) and remove a razzhimny level (109).
  2. Installation is made upside-down, - the persistent and sliding surfaces of a razzhimny level (109) before installation should be greased with jellied molibdensoderzhashchy lubricant, grease with the same lubricant a carving of a persistent element (104), and also a cylindrical part of an adjusting castor (c). At installation actually of boots release the adjusting mechanism and track that a regulator castor (c) it appeared in detail down, track correctness of connection of coupling (111 and 112) and anchor (107) springs.
  3. Make adjustment of the parking brake (see the Section Adjustment of the Drive of the Parking Brake) and unload the automatic regulator.