Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
- Current leaving and service
   Active system of the warning of the term of approach planned THAT (ASSYST)
   Schedule of routine maintenance
   General information on settings
   Check of levels of liquids, control of leaks
   Check of a condition of tires and pressure in them, designation of tires and disks of wheels, rotation of wheels
   Replacement of motive oil and oil filter
   Check of the brake system
   Check of a power supply system, replacement of the fuel filter
   Check of a state and replacement of hoses of a motive compartment, localization of leaks
   Check of a condition of multicostal belts of the drive of auxiliary units
   Check of functioning of the cooling system and frost resistance of cooling liquid, liquid replacement
   Check of a condition of system of production of the fulfilled gases
   Replacement and check of the ATF level, replacement of the AT filter
   Visual check of tightness of automatic transmission
   Check of a condition of components of a suspension bracket and steering
   Check of a condition of boots of power shafts
   Check of the air conditioning system
   Lubricant of limiters of doors and cylinders of locks
   Visual control of a seat belt and block of a safety cushion
   Check of operability of headlights and horn
   Check of a state and replacement of brushes of screen wipers
   Check of a condition of the battery, care of it and charging
   Replacement of the saloon filter
   Replacement of brake fluid
   Check and replacement of spark plugs, check of a condition of high-voltage wires (petrol models)
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Visual check of tightness of automatic transmission

 PERFORMANCE ORDER

Oil in AT is not required to be changed during all term of operation.

  1. The following is among the most probable places of development of leakages of ATF:

    · Plane of a joint of the block of cylinders and AT (back epiploon of the crankshaft);
    · The place of connection of a power shaft to the transmission;
    · Drain stopper;
    · Jellied stopper.

  2. Clear AT case.
  3. Sprinkle possible places of leaks with a thin layer of chalk or talc.
  4. Make a trial trip on distance about 30 kilometers.
  5. Lift the car on the elevator or over a viewing hole and determine the place of leak of oil by smudges of oil.
  6. Eliminate leak and fill in oil in the transmission.