Mercedes M-Class W163

since 1997 release

Repair and operation of the car

Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
- Current leaving and service
   Active system of the warning of the term of approach planned THAT (ASSYST)
   Schedule of routine maintenance
   General information on settings
   Check of levels of liquids, control of leaks
   Check of a condition of tires and pressure in them, designation of tires and disks of wheels, rotation of wheels
   Replacement of motive oil and oil filter
   Check of the brake system
   Check of a power supply system, replacement of the fuel filter
   Check of a state and replacement of hoses of a motive compartment, localization of leaks
   Check of a condition of multicostal belts of the drive of auxiliary units
   Check of functioning of the cooling system and frost resistance of cooling liquid, liquid replacement
   Check of a condition of system of production of the fulfilled gases
   Replacement and check of the ATF level, replacement of the AT filter
   Visual check of tightness of automatic transmission
   Check of a condition of components of a suspension bracket and steering
   Check of a condition of boots of power shafts
   Check of the air conditioning system
   Lubricant of limiters of doors and cylinders of locks
   Visual control of a seat belt and block of a safety cushion
   Check of operability of headlights and horn
   Check of a state and replacement of brushes of screen wipers
   Check of a condition of the battery, care of it and charging
   Replacement of the saloon filter
   Replacement of brake fluid
   Check and replacement of spark plugs, check of a condition of high-voltage wires (petrol models)
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Visual control of a seat belt and block of a safety cushion


  1. Completely extend a seat belt and check a tape for availability of the damaged threads).

    Check a tape of a belt for availability of the damaged threads

  2. Damages can be a consequence, for example, of jamming of a belt or influence of the burning cigarette. In this case the belt should be replaced.
  3. In the presence of mastications without signs of damage of threads it is not necessary to replace a belt.
  4. The belt having the heavy course should be checked for twisting. If necessary it is necessary to remove facing on the central rack.
  5. If the automatic machine of taking-up does not work, the belt needs to be replaced (work HUNDRED).
  6. The tape of a belt can be cleared only soap and water. It is not necessary to apply for this purpose solvents or chemical cleaners at all.
  7. Check installation sites of safety cushions for existence of damages.
  8. You clean a surface of a steering wheel and panels under which knots of inflatable safety cushions are located the dry or moisturized with water rag.

It is not allowed to paste over or fit any material a steering wheel and the surface of the forward panel on the right.