Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
- Body
   - External equipment and body elements
      Removal and installation of levers of screen wipers
      Removal of the drive of forward screen wipers
      Removal and installation of sliding telescopic snuffled faroomyvatel
      Removal, installation and adjustment of a cowl
      Replacement of loops of a cowl
      Removal and installation of an emblem Mercedes
      Removal, installation and service of components of the lock of a cowl
      Removal and installation of a gas-filled emphasis of fixing of a cowl in open situation
      Removal and installation of the tank of the washing liquid
      Removal and installation of a front bumper
      Removal and installation of the top forward cross beam of a frame
      Removal and installation of panels of the lower protection of a motive compartment
      Removal and installation of a rear bumper
      Removal and installation of the external holder of a spare wheel (at the corresponding complete set)
      Removal and installation of loker of protection of wheel arches
      Removal and installation of doors
      Removal and installation of limiters of opening of side doors
      Removal and installation of loops of a door of a back
      Removal and installation of a gas-filled sliding emphasis of a door of a back
      Removal and installation of external handles of doors
      Removal and installation of panels of an internal upholstery of door assemblies
      Removal and installation of door locks
      Removal and installation of door rear-view mirrors
   + Equipment of salon
+ Onboard electric equipment



Removal of the drive of forward screen wipers

Details of installation of a cover of an air inlet

Details of installation of the drive of forward screen wipers


 PERFORMANCE ORDER

  1. Details of installation of the drive of screenwashes are shown on an illustration to which all references which are found in the text belong.
  2. Make sure that brushes are stopped in parking situation and remove levers of screen wipers (1) (see the Section Removal and installation of levers of screen wipers).
  3. Remove from a partition of a motive compartment a rubber sealant (2).
  4. Release metal clamps (5), give nuts (4) and remove a foam insert.
  5. Seal a hose of supply of the washing liquid on the control valve.
  6. Uncover an air inlet (3) complete with the panel of a water reflector (6).
  7. Uncover an air inlet.
  8. Release nuts (7) and carefully remove the driving mechanism (8).
  9. In case of need disconnect an electrical wiring (9) and remove an electric motor (M6/1).
  10. Installation is made upside-down, - replace the failed sealing elements of a cover of an air inlet, before installation grease the upper edge of a cover and a surface of a windshield with soap solution.