Repair and service Mercedes Benz M - The Class W163 - Replacement of loops of a cowl//since 1997 release /

Mercedes M-Class W163

since 1997 release

Repair and operation of the car



Mercedes W163
+ Mercedes-Benz cars of a class M (W163)
+ Governing bodies and methods of safe operation
+ Current leaving and service
+ Engine
+ Cooling systems, heating and air conditioner
+ A power supply system and production of the fulfilled gases
+ Systems of electric equipment of the engine
+ Manual box of gear shifting
+ Automatic transmission
+ Transmission line
+ Brake and auxiliary systems
+ Suspension bracket and steering
- Body
   - External equipment and body elements
      Removal and installation of levers of screen wipers
      Removal of the drive of forward screen wipers
      Removal and installation of sliding telescopic snuffled faroomyvatel
      Removal, installation and adjustment of a cowl
      Replacement of loops of a cowl
      Removal and installation of an emblem Mercedes
      Removal, installation and service of components of the lock of a cowl
      Removal and installation of a gas-filled emphasis of fixing of a cowl in open situation
      Removal and installation of the tank of the washing liquid
      Removal and installation of a front bumper
      Removal and installation of the top forward cross beam of a frame
      Removal and installation of panels of the lower protection of a motive compartment
      Removal and installation of a rear bumper
      Removal and installation of the external holder of a spare wheel (at the corresponding complete set)
      Removal and installation of loker of protection of wheel arches
      Removal and installation of doors
      Removal and installation of limiters of opening of side doors
      Removal and installation of loops of a door of a back
      Removal and installation of a gas-filled sliding emphasis of a door of a back
      Removal and installation of external handles of doors
      Removal and installation of panels of an internal upholstery of door assemblies
      Removal and installation of door locks
      Removal and installation of door rear-view mirrors
   + Equipment of salon
+ Onboard electric equipment



Replacement of loops of a cowl

Screws (1) of fastening of a loopy level to a cowl

Nuts (3) fastenings of loopy assembly (2) to the body panel


 PERFORMANCE ORDER

  1. Details of installation of loopy levels of a cowl are shown on illustrations to which all references which are found in the text belong.
  2. If both loops are subject to replacement, remove a cowl (see the Section Removal, installation and adjustment of a cowl) if one, - open it and record in vertical position.
  3. Uncover an air inlet (see the Section Removal of the Drive of Forward Screen Wipers).
  4. Remove a rubber overlay of a loop, - slips are subject to replacement without fail.
  5. Cut off a sealant around a loop so that to provide freedom of the course of the last, - a sealant are subject to replacement without fail, at installation the sealant should be painted.
  6. Mark the provision of loopy levels.
  7. Remove a gas-filled emphasis (see the Section Removal and installation of a gas-filled emphasis of fixing of a cowl in open situation).
  8. Turn out fixing screws (1) and give nuts (3).
  9. Remove loopy assembly (2).
  10. Installation is made upside-down, - track that loopy levels were established according to the marking put in the course of dismantle.
  11. Check correctness of provision of a cowl, in case of need make the corresponding adjustment (see the Section Removal, installation and adjustment of a cowl).